top of page

Western Australia’s exposure-limit change: what applies now and from December 2026

1 hour ago
2 min read

A commencement date, not an immediate replacement


As checked on 15 November 2026, Western Australia has enacted its workplace exposure-limit amendments, but their substantive operation begins on 1 December 2026. Publication on 11 November did not bring those substantive changes forward. The amendments affect both the General and Mines Regulations. See the Work Health and Safety Legislation (Workplace Exposure Limits) Amendment Regulations 2026, regulation 2 and Parts 2–3, printed pages 1–14.


For workplaces covered by the General Regulations, the existing exposure-standard obligation remains relevant before commencement. Regulation 49 prohibits exposure above the applicable standard and separately addresses airborne dust without a substance-specific standard. Regulation 50 requires air monitoring where the stated uncertainty or health-risk conditions arise, recording of results, and access for potentially exposed people. A new terminology announcement does not suspend those duties. General Regulations, compilation as at 11 November 2026, regulations 49–50, printed pages 67–68.


WA’s modifications matter


The new definitions adopt the November 2025 national WEL document with WA modifications. New regulation 48A removes the diesel-particulate-matter row for the General Regulations, while the Mines version substitutes a locally specified limit and measurement basis. Both contain a phosphine variation continuing through 30 November 2029. Do not copy a national table without checking the applicable WA sector instrument. Amending regulations 4, 6, 18 and 20, printed pages 2–3 and 8–10.


Benzene needs a separate diary entry. WorkSafe WA identifies 1 June 2027 for its revised limit. Treat this as a distinct transition and recheck the operative WA instrument before applying a later concentration. WorkSafe WA transition update.


Practical preparation for public-sector and correctional workplaces


A useful preparation register identifies each contaminant, where it is used or generated, the people potentially exposed, the relevant sector instrument, existing controls, monitoring evidence and the applicable change date. For a correctional workplace, investigate actual cleaning, maintenance, workshop and vehicle activities rather than assuming every listed chemical is present.


Ask a competent adviser to review the controls and measurement approach where a limit is removed or falls below reliable measurement capability. Absence of a listed limit is not evidence that exposure is harmless. WorkSafe specifically recommends competent review, maintenance checks and a review schedule in these circumstances. WorkSafe WA, “Managing risk where there is no WEL or where exposures are too low to effectively measure”.


This guide intentionally does not reproduce concentration figures. Before using a number, verify the substance identity, units, averaging period, sampling fraction and current WA modification against the operative instrument and source table. Preserve the source version with the assessment and distinguish measured findings from assumptions or untested exposure concerns.


 
 
 

Recent Posts

See All

Comments


bottom of page